How to disconnect drain stoppers in sinks.
Delta bathroom sink drain plug removal.
To remove the stopper you have to disassemble this linkage.
Disconnect the clevis slide it off the pivot arm and unscrew the nut holding the pivot arm to the tailpiece.
When you pull up on the small lever at the back of your bathroom sink faucet it lowers the stopper into the drain.
Reach up with your hand to see if you can remove it by hand.
Remove soap scum or hair from stopper.
Remove a sink pop up drain with help from a master plumber in this fre.
With the stopper in the open position simply grasp the plug by hand and pull upwards with a wiggling motion to remove it from the drain opening.
Locate the nut on the sidewall of the drainpipe.
If it doesn t turn use pliers to remove the nut.
The toe tap stopper also unscrews counterclockwise while in the full up position.
Beneath the sink use your hand or a pipe wrench to unscrew the connection where the tailpiece enters the drain.
However the cap may unscrew from the plunger assembly before the entire stopper comes out.
A delta sink stopper connects to the lift rod behind the faucet by a linkage.
The lift turn stopper for the bathtub unscrews counterclockwise while in the full up position.
Test to see if water is leaking around the flange by plugging your drain with a rubber stopper.
For a pop up drain assembly.
A sink pop up drain can be removed from its location at the bottom of a bathroom sink.
This will free up the rod leading to the sink stopper.
To remove the flange.
Then go back to the clip and squeeze the ends together.
Browse bath products by product type or scroll below to view catalogs and plumbing codes or search for support and repair parts.
Pull out the pivot arm to free the stopper.
The stopper allows you to fill the.
Scrape off any old putty and wipe the surface clean with a damp cloth.
Pull the flange straight up through the sink.
Use the channel lock pliers to unscrew the large nut at the bottom of the sink.
Remove soap scum or hair from drain use a small scrub brush to remove soap scum or hair inside the drain opening.
This will allow you to push the plunger rod out.
Do not cover the outside of the drain flange.